Sizing a Concrete RV Pad for Fifth Wheels in Driggs

Concrete RV pads in Driggs, ID must be sized for your actual rig dimensions and thickened beyond four inches if you park a fifth wheel, because stabilizer jack loads concentrate weight at points that crack standard residential slabs.

How Do You Measure the Right Pad Size?

Measure your RV from bumper to hitch and add two feet on each end, then add width for slide-outs if they extend while parked.

Too many homeowners guess at pad size and end up with a slab that is either too small to hold the rig or too large and expensive for no reason. Start with your RV's actual length—the distance from the rear bumper to the front hitch or tongue. Add at least two feet on each end so you have room to maneuver and so tires do not sit right at the slab edge where cracking starts.

Width depends on whether you deploy slide-outs while the rig is parked. If you do, measure the full extended width and add a foot on each side. If you keep slides in, measure the body width and add the same margin. If you are planning other site concrete near you, concrete driveway services in Driggs can often be scheduled together to prepare the entire property at once.

What Thickness Works for Fifth Wheels?

Standard RV pads are four inches thick, but fifth wheels and heavier rigs need increased thickness to handle stabilizer jack point loads without cracking.

A travel trailer or smaller motorhome distributes weight across four or six tires. A fifth wheel adds a hitch that transfers thousands of pounds to the truck bed, and it uses stabilizer jacks at the corners to keep the rig level. Those jacks create intense point loads—far more pressure per square inch than tires spread out.

Wolverine Concrete adjusts slab thickness based on what you are parking. Four inches is standard. Heavier rigs and fifth wheels often get five inches. The decision is made after looking at your RV's specs and how you will use the pad. That is not a flat-rate pour—it is a design choice.

Does Slope Matter on an RV Pad?

Yes—RV pads are sloped for water runoff as standard, so rain and snowmelt do not pool under the rig or against the slab edges.

Standing water is a problem for two reasons. First, it accelerates rust on your RV frame and undercarriage. Second, it seeps underneath the slab and freezes during eastern Idaho winters, causing the same heaving and cracking that damages driveways and patios.

Every Wolverine Concrete RV pad is sloped to move water off the surface. The grade is gentle—you will not feel it when you level your rig—but it is enough to keep water from sitting. If you are also adding walkways or entry steps, concrete sidewalk services in Driggs are designed with the same drainage principles in mind.

How Does Eastern Idaho's RV Culture Affect Pad Design?

Long winters and heavy rigs mean pads must hold significant loads year-round without cracking, settling, or losing edge support at stabilizer points.

Driggs, ID sits in a region where RV ownership is common and rigs often stay parked through the winter. That means your pad is under load for months at a time, cycling through freeze and thaw while supporting several tons of steel and aluminum. If the thickness was not adjusted for your rig or the edges were not properly formed, you will see cracks and settlement by spring.

Forty years of residential concrete work in eastern Idaho taught Wolverine Concrete what holds up and what fails. RV pads are not one-size jobs—they are custom pours based on what you are parking and how long it will sit there.

RV pads in Driggs, ID last when the contractor sizes and builds them for the actual rig and the actual climate, not a generic template.

Explore your RV pad options with Wolverine Concrete by calling 208-390-9521 and discussing your rig's specs and site layout.